Oil Analysis for water treatment

YOU ARE
PROFESSIONAL OF WATER TREATMENT

IESPM is following the professionals of water treatment sector for more than 30 years. The oil condition monitoring is present in all the installations dedicated to the water cycle and its treatment. The fluid analysis allows to insure an effective maintenance of specific materials of these infrastructures:

• Water captation or desalination plants : rakes, inverted leaves, locks, gates, hydraulic regulation systems, pumps, transformers or generators …
• Systems of distribution networks : pumps, filtrations, gates, reducers, multipliers …
• Water-treatment plants : turbines, gates, mechanical agitators, mud press, mud extractors, sand wringers, mud conveyors, clarifiers …

Oil condition monitoring (oil, grease, dielectric fluid) for water treatment equipments allows you: to anticipate the breakdowns, to plan each interventions, to master your maintenance costs, to increase availability and thus productivity of materials.

OUR APPROACH

We assit you throughout the life cycle of materials dedicated to water treatment from the installation to the maintenance by oil condition monitoring.

– From the acquisition of materials

We accompany you to implement an adapted oil condition monitoring : definition of the strategic organs to control, selection of a sampling protocol, sampling planning, Point ZERO (evaluation of initial properties) …

– During and after the warranty period of materials

You must avoid mechanical malfunctions and unplanned downtimes. In this context, we accompany you in the monitoring of your materials for an effective preventive maintenance : monitoring set up (selection of analysis and sampling frequencies), management of the unforeseen, health follow-up of material organs, monitoring reports and experience feedback.

OUR METHODOLOGY : 5 KEY STEPS FOR SUCCESSFUL MONITORING

• Step 1
• Step 2
• Step 3
• Step 4
• Step 5
• DiagServer

OUR SERVICES

This post is also available in: French